Clear and Clean Blocked Drain Lines
Cleaning and restoring flow to clogged drain lines
Posted 14:26 June 07, 2021
Last Updated 08:17 August 09, 2021
Eventually all plumbing systems develop clogs. Clogs can develop in sink lines, toilet lines, or any other drain line. How to clear the clog depends upon the clog itself, the location, and the condition of the drain line. A simple clog in a sink line may only require removing the sink trap and clearing the clog. More complex clogs will require more advanced techniques. Here are a few tips and techniques to clear common everyday clogs and blockages in homeowner drain lines.
Where is the clog?
This is not always as easy as it sounds but the technique is always the same. Start at the clog point and work your way back until you find the blockage. Very simple clogs may be only a few inches back. A clog that is very deep into the plumbing system will make it difficult or almost impossible to source.
Clearing simple clogged drains
A simple blockage that is only a few inches back can be cleared by hand. If you can't reach it, a simple tool (such as a screwdriver or coat hanger) can be used to extend your reach. If it's a sink drain, check the drain trap. It's fairly easy to remove a drain trap with a pair of pliers or a wrench. Clean the trap of any debris.
If you can't get to the clog by hand, a plunger is often a very effective tool. Don't waste your money on expensive, complex plungers. The cheapest, most simple plunger is often the best tool for the job. Plungers aren't just for toilets. They're great for any type of drain. To successfully plunge a drain you'll want to:
• Clear as much excess water from the drain as possible.
• Make sure the plunger base totally covers the drain.
• Press down firmly to create a seal.
• Pull up and down on the plunger semi-rapidly, keeping the seal intact, for 15-30 seconds.
The plunger creates a back and forth flow of the water between the plunger and the blockage. If the blockage isn't too far away, and if the blockage isn't too thick, the plunging water will clear the drain. The blockage will either push straight through or it will break the clog up into smaller pieces and then clear it.
Clearing moderately clogged drains
If the blockage is further back, seven to ten feet or more, a plunger may not be able to create enough force to clear the clogged drain. Snaking the drain with a drain auger will often clear the drain.
Start turning the snake cable clockwise. You goal is to hook into it and either pull it out, or, hook into it and then break it up into smaller pieces until the blockage clears.
If the clog doesn't budge or you can't hook it, the blockage may be a solid object. You'll need to attempt a more advanced technique.
If you can't reach the clog, you'll need to try a more advanced technique.
Clearing severely clogged drains
When the drain blockage is very far from the drain opening, or the blockage is solid, thick, or very stiff, it must be cleared with a more professional approach. Hydro jetting is a professional drain clearing method used by plumbers. It is very effective at clearing stubborn blockages. Water is blasted through your pipelines at around 4000 psi.
Hydro jetting clears the most difficult blockages. Hydro jetting can remove sand, silt, hair, or virtually any type of clog. It is fast and effective. If your pipelines were repaired with a trenchless pipe lining or cured-in-place pipe (CIPP) solution in the past, your lines must be cleaned with hydro jetting. Snaking a CIPP can damage it.
Hydro jetting requires professional equipment and should only be performed by a licensed plumber contractor. All Trades has decades of experience in hydro jetting. We can clear and clean your drains quickly and safely. We service all areas of Las Vegas, Nevada including Henderson, Boulder City, and Clark County.
